| |
|
| |
Intermediate
worm shaft disassembly FW713-FW726
| • |
With screwdriver,
pierce input bore plug and remove from housing bore.
[photo]
|
Models FW 732-FW738
| • |
Remove bearing
retainer screws and bearing retainer. |
Models FW713-FW730
| • |
Remove outboard retaining ring from
housing bore.
[photo]
|
Models FW713-FW738
| • |
Remove 4-6 screws from attachment
cover and remove from housing. [photo] |
| • |
Remove screw, lock washer and washer
[photo]
|
| • |
Remove intermediate worm assembly
through bore opposite attachment housing.
[photo]
|
|
|
|
|
| |
|
| |
Models FW713-FW730
| • |
Check condition of ball bearings.
Bearings should roll smoothly and not bind.
If
bearings need replacement, press shaft through
bearings. Install new bearing onto shaft. If
not
already packed with grease, bearings should be
packed at least 50% full with Lubux XP #2.
[photo] |
Models FW732-FW738
| • |
Check tapered roller bearing
for signs of contamination or discoloration. Rollers
should not bind or exhibit flat spots. Bearings
should be packed at least 50% full with Lubux
XP #2. |
Intermediate worm gear
| • |
Remove from attachment housing.
Shims and gear spacer should be set aside for
re-assembly. Note: Gear teeth will be damaged
if intermediate worm gear is removed before intermediate
shaft is removed. [photo] |
|
|
|
|
|
|
|
