| • |
Insert input worm assembly into the
housing. Seat the ball bearing against the inner retaining
ring [photo] |
| • |
Install the metal shims [photo] |
| • |
Assemble outboard snap ring [photo] |
| • |
Clean housing bores in the area where
the oil seals will be installed |
| • |
Install input oil seal(s) [photo] |
| • |
For rubber clad oil seals apply all
purpose grease (NLGI #2 consistency) to the ID and OD
[photo] |
| • |
For steel clad oil seals apply all
purpose grease to the ID only and coat bore evenly with
Permatex Form A Gasket #3 sealant [photo] |
| • |
Slide new seal over input shaft until
it contacts the housing. Be careful not to damage oil
seal lip. |
| • |
Tap oil seal casing gently using
a small hammer [photo] |
