| |
|
| |
Input
shaft reassembly | Models F710-F738
| • |
Insert input worm shaft assembly
into housing with retaining ring used to seat ball
bearing. [photo] |
| • |
Install metal shims. [photo] |
| • |
Assemble outboard snap ring. [photo] |
| • |
Clean housing bores in area where
oils seals is to be inserted. |
Input
shaft reassembly | Models F732-F738
| • |
Insert input worm shaft assembly
into housing with retaining ring used to seat ball bearing.
[photo] |
| • |
Install metal shims.
[photo] |
| • |
Assemble outboard snap ring.
[photo] |
| • |
Clean housing bores in area where
oils seals is to be inserted. |
Oil seal assembly:
| • |
Rubber clad
oil seals: apply all purpose grease (NLGI #2 consistency)
to ID and OD [photo] |
| • |
Steel clad oil seals: apply all purpose
grease to ID only and coat bore evenly with Permatex
aviation former gasket #3 or equivalent. |
| • |
Insert new oil seal over shaft until
it contacts the housing. Care
must be taken not to damage oil seal lip. |
|
|
|
|
