| • |
Place output gear assembly into a
pressing fixture and remove the worm gear from the shaft |
| • |
With the gear key assembled in the
shaft key seat, press the new gear on to the shaft to
the dimensions shown. [fig
1 page 15] |
| • |
Install the shaft spacer and grease
cups |
| • |
Press the bearings cones onto the
shaft making sure the assembly is tight. (no space between
items) |
| • |
Re-measure from the end of the shaft
to the face of the gear as shown [fig
1 page 15]. Readjust, if necessary, by pressing
on the bearing cone until desired dimension is achieved. |
| • |
Where grease cups are used, pack
with Mobilux EP #2 all purpose grease, or equivalent.
|
